Adc EMU-830 Manual do Utilizador descarregar pdf (Página 53)

September 25, 2006 Chapter 3: Provisioning

LTPE-UM-3159-02 3-21

To specify a terminal setting, do one of the following:

Set to Factory Defaults

In the Config menu, press F to display the "restore to factory defaults" warning prompt (Figure 3-16).

Figure 3-16. Restore To Factory Defaults Warning Prompt

Do one of the following:

• Press Y (yes) to reset the EMU to factory default settings (then log on to the EMU console menu if you wish to

make configuration changes).

• Press N (no) to retain your special configuration settings.

Step Action

1 If you are not using a Windows terminal, select a menu item with the best horizontal line, then press

ENTER. For example, "_ _ _ _ _" versus "________", where "________" is the best.

2 If you are using a Windows terminal, select the Windows Terminal menu item, then press ENTER.

IMPORTANT

Pressing Y in this screen resets the EMU-830 to factory default settings, which erases any special

configuration settings you have specified.

Note: Resetting the EMU to factory defaults will reset the EMU and log you off from the EMU console menu

and requires that you log on again on to regain access. All alarm reporting information is lost.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 73 74

Sem comentários

Adc EMU-830 Manual do Utilizador Página 53