Adc SG-1 Manual do Utilizador descarregar pdf (Página 151)

June 30, 2006 Chapter 7: Second Level Commands

SG1-UM-8500-03 7-71

Example(s)

DEBUG COMMANDS

Use the commands at the second level prompt to switch the system to the second-level debug prompt,

Host(config-debug)#. This indicates that the user is now in the second level debug mode and has access to the

commands in the debug menu.

There are three types of messages sent by the POPmaestro/SG-1 system to its logger. They are: Error Log, Event

Log and Trace Log.

Error Log

An Error Log is a message sent by the system when an error that requires an operator's attention occurs. It can be

either an internal error in the system's operation (usually this would be a high-level error) or an error caused from

outside the system (like wrong data sent to the system).

Trace Log

A Trace Log is a message that outputs the contents of some buffer or some area in the memory, as a result of a

certain event. It can be either when an error occurs, or when it is important to view a certain stream of bytes, like an

important received packet.

Event Log

An Event Log is a message-documenting occurrence of an event in the system.

Configure watchdog

Usage

(config-debug)# watchdog-TimeValue <number>

Parameter

It is the timeout in seconds (0 = unlimited)

Example

Host(config)# vrrp preempt interface VLAN 1\2 7 enable

(config-debug)# watchdog-TimeValue

(config-debug)# watchdog-TimeValue 60 (cr)

(config-debug)#

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 225 226

Sem comentários

Adc SG-1 Manual do Utilizador Página 151