ADC 410F Instruções de Operação descarregar pdf (Página 18)

3/1

3 Start-up

3.1 Switch-on and measurement

• Before powering the system, please check that it has been correctly installed according

to Sect. 1 and 2.

• The flowmeter is delivered ready for operational use. All operating data have

been factory set in accordance with your specifications.

Please refer to Sect. 3.2 “factory settings”.

• Power the unit, and the flowmeter will immediately start process flow

measurement.

Basic version

, signal converter IFC 090 / B

• A light emitting diode (LED) under the cover of the electronic section shows the

measurement status. Remove the cover using the special wrench.

LED flashing . . .

green: measurement correct, everything all right.

green / red: momentary overdriving of outputs

and/or A/D converter.

red: fatal error, parameter error or hardware fault,

please consult factory.

• Refer to Sect. 6.2 for operator control of the “basic version”.

Display version, signal converter IFC 090 / D

• When powered, the display shows in succession: START UP and READY.

This is followed by display of the current flow rate and/or the current totalizer count

on either a continuous or alternating basis, depending on the setting under Fct. 1.04.

• Refer to Sect. 4 and 5 for operator control of the “display version”.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 78 79

Sem comentários

ADC 410F Instruções de Operação Página 18